ABBCO Car Service · Kraków, Nowa Huta
Exhaust system repair Kraków
We repair and replace exhaust system parts: silencers, pipes, flexible joints, clamps and hangers. We weld cracked pipes and rusted joints. We inspect the car on a lift and quote the repair before starting work.
after inspectionquote before repair
liftwe check the whole system
Mon–Fri 8–18ul. Wysockiej 9

What we repair in the exhaust system
- Silencers. Replacing a rusted or holed centre or rear silencer.
- Pipes and bends. Replacing or welding in a section of pipe where it has rusted through or cracked.
- Flexible joint (flex pipe). Replacing a torn braided flex pipe behind the manifold – a typical cause of loud running and rattling.
- Hangers and rubbers. Replacing broken hangers, rubbers and clamps – the exhaust stops knocking and sagging.
- Gaskets and joints. Sealing leaking joints between components.
- Heat shields. Securing or removing a loose, rattling shield.
Signs of a damaged exhaust
- The car is noticeably louder than usual
- Rattling or knocking from under the car when pulling away and over bumps
- Exhaust smell in the cabin
- The exhaust hangs lower than usual or hits the underbody
- A visible hole, rust or black soot at a joint
- Loss of power and higher fuel consumption (possible blockage)
An exhaust smell in the cabin is a signal to come in straight away – carbon monoxide is odourless, but it accompanies the exhaust fumes you can smell.
How the repair works
- 1. Inspection on a lift. We check the whole system from the manifold to the tailpipe: leaks, corrosion, mountings.
- 2. Quote. We tell you what needs doing and how much it costs – replacing a part or repairing it by welding.
- 3. Repair. We replace parts or weld damaged spots, and replace clamps and rubbers.
- 4. Inspection. We check for leaks with the engine running and make sure the exhaust doesn’t touch the underbody anywhere.
Catalytic converter and DPF
We start a catalytic converter or particulate filter fault with computer diagnostics – the cause is often a sensor, a lambda probe or a leak rather than the part itself.
Remember: a car without the catalytic converter or DPF required for its model will not pass the roadworthiness test, and driving such a car is against the law.
Replace or weld?
If a part is rusted along a long section, has rotten walls or is a silencer with a hole in its body – replacement pays off. Welding makes sense for a crack in one place, a damaged hanger or a short section of pipe in good condition.
We will advise honestly – repairing one joint often costs a fraction of a new silencer.
No ready-made part?
For older, rare or imported cars a ready-made silencer is sometimes unavailable or very expensive. Then we can make a section of the system to measure – see exhaust system fabrication.
Frequently asked questions
A short guide to what customers ask most often.
- How much does an exhaust repair cost?It depends on what is damaged and the condition of the rest of the system. We give a quote after inspection on a lift, before starting work.
- How long does an exhaust repair take?It depends on the scope and parts availability – we give the time together with the quote after inspection.
- Can I drive with a holed silencer?For a short time yes, but the car is louder, may fail the roadworthiness test, and fumes can get into the cabin. Better not to wait.
- Do you weld exhausts?Yes – cracked pipes, joints and hangers. If a part is too badly damaged, we recommend replacement.
- Do you remove catalytic converters or DPFs?Removing a catalytic converter or DPF required for the car is against the law and the car will not pass the roadworthiness test. We diagnose and repair these systems.
- Can I come without an appointment?Best to call ahead – the lift may be busy. Tel. 12 649 32 33.
See also
Other services related to this one.
- Exhaust system fabrication – custom-made exhaust
- Car mechanics – diagnostics and repairs
- Underbody protection – corrosion protection
- Car air conditioning – service from 150 PLN
- Tyre change – during the same visit
Loud exhaust? Come in for an inspection
ul. Stanisławy Wysockiej 9, Kraków (Nowa Huta) · Mon–Fri 8:00–18:00 · tel. +48 12 649 32 33 or +48 12 640 22 30
