ABBCO Car Service · Kraków, Nowa Huta

Exhaust system repair Kraków

We repair and replace exhaust system parts: silencers, pipes, flexible joints, clamps and hangers. We weld cracked pipes and rusted joints. We inspect the car on a lift and quote the repair before starting work.

after inspectionquote before repair

liftwe check the whole system

Mon–Fri 8–18ul. Wysockiej 9

Mechanik naprawia układ wydechowy pod samochodem w warsztacie ABBCO w Krakowie

What we repair in the exhaust system

  • Silencers. Replacing a rusted or holed centre or rear silencer.
  • Pipes and bends. Replacing or welding in a section of pipe where it has rusted through or cracked.
  • Flexible joint (flex pipe). Replacing a torn braided flex pipe behind the manifold – a typical cause of loud running and rattling.
  • Hangers and rubbers. Replacing broken hangers, rubbers and clamps – the exhaust stops knocking and sagging.
  • Gaskets and joints. Sealing leaking joints between components.
  • Heat shields. Securing or removing a loose, rattling shield.

Signs of a damaged exhaust

  • The car is noticeably louder than usual
  • Rattling or knocking from under the car when pulling away and over bumps
  • Exhaust smell in the cabin
  • The exhaust hangs lower than usual or hits the underbody
  • A visible hole, rust or black soot at a joint
  • Loss of power and higher fuel consumption (possible blockage)

An exhaust smell in the cabin is a signal to come in straight away – carbon monoxide is odourless, but it accompanies the exhaust fumes you can smell.

How the repair works

  • 1. Inspection on a lift. We check the whole system from the manifold to the tailpipe: leaks, corrosion, mountings.
  • 2. Quote. We tell you what needs doing and how much it costs – replacing a part or repairing it by welding.
  • 3. Repair. We replace parts or weld damaged spots, and replace clamps and rubbers.
  • 4. Inspection. We check for leaks with the engine running and make sure the exhaust doesn’t touch the underbody anywhere.

Catalytic converter and DPF

We start a catalytic converter or particulate filter fault with computer diagnostics – the cause is often a sensor, a lambda probe or a leak rather than the part itself.

Remember: a car without the catalytic converter or DPF required for its model will not pass the roadworthiness test, and driving such a car is against the law.

Replace or weld?

If a part is rusted along a long section, has rotten walls or is a silencer with a hole in its body – replacement pays off. Welding makes sense for a crack in one place, a damaged hanger or a short section of pipe in good condition.

We will advise honestly – repairing one joint often costs a fraction of a new silencer.

No ready-made part?

For older, rare or imported cars a ready-made silencer is sometimes unavailable or very expensive. Then we can make a section of the system to measure – see exhaust system fabrication.

Frequently asked questions

A short guide to what customers ask most often.

  • How much does an exhaust repair cost?It depends on what is damaged and the condition of the rest of the system. We give a quote after inspection on a lift, before starting work.
  • How long does an exhaust repair take?It depends on the scope and parts availability – we give the time together with the quote after inspection.
  • Can I drive with a holed silencer?For a short time yes, but the car is louder, may fail the roadworthiness test, and fumes can get into the cabin. Better not to wait.
  • Do you weld exhausts?Yes – cracked pipes, joints and hangers. If a part is too badly damaged, we recommend replacement.
  • Do you remove catalytic converters or DPFs?Removing a catalytic converter or DPF required for the car is against the law and the car will not pass the roadworthiness test. We diagnose and repair these systems.
  • Can I come without an appointment?Best to call ahead – the lift may be busy. Tel. 12 649 32 33.

See also

Other services related to this one.

Loud exhaust? Come in for an inspection

ul. Stanisławy Wysockiej 9, Kraków (Nowa Huta) · Mon–Fri 8:00–18:00 · tel. +48 12 649 32 33 or +48 12 640 22 30